Today we made a lot of changes from our initial design of our
robot. We made it so that the robot will
be able to hold the sprinkles without tape; our initial design involved taping
the sprinkles to a contraption on the motor.
We were able to attach and secure that sprinkles without tape by using
two bend pieces connect to each other to that the flat part is on the bottom
and it curves upward. We made two of
these and attached the ends to rods on both sides and then attached a straight
beam on the end of it and used converting pieces to connect the beam to the
rods. Then we attached a front part
that goes across the front and leaves just enough room for the sprinkles to get
through. We attached the front beams
with the connectors that snap into the holes.
No comments:
Post a Comment